EN Menu
Close

HW252-F TI & CI (BW)

Installation instructions

1.

2.

Mark the width using the box as a template.

3.

4.

5.

6.

Pull on the Fix-Raps, possibly with the help of a screwdriver.

7.

Bend the Fix-Raps inwards to break them off, do not twist.

8.

Cut the flexible conduit to the desired length.

9. For use in thin walls

With thin walls, the Fix-Raps can jam against the rear wall. Therefore, follow the following instructions.

10.

Pull on the 3 cm Fix-Raps.

11.

Press the box into the desired position in the Ø 76 mm drilled hole and then follow the instruction from point 4.

12.

Conduit type: HW52-F MT TI

  1. Remove the rear side knockout to allow the use of the side cutting pliers.
  2. Cut out the bottom part partially with side cutting pliers.

13.

14. Cable insert HW252-F CI

Place the cable in the box. Push a lip up and slide the cable into the box. Attach the cable to the lip with a Ty-Rap®

Cable conduit type: HW252-F CI

15. Insert airtight and soundproof

Insert type: HW252-F IGD-U

Push the conductors through the membrane and place the insert in the box.

Only suitable for use with the HW252-F, not for the HW252-F BW (fire retardant).

16.

Optional: apply an acrylic sealant on the edge for optimum airtightness.

To top To top